Full description

About POULTICE PLUS

Poultice Plus is a pre-mixed, non-flammable poultice paste that helps remove stains such as oil, coffee, tea and red wine from stone, tile, concrete and grout.

Technical Bulletin (PDF) ›
Description

Poultice Plus is a non flammable and easy to use pre-mixed poultice paste that helps remove most stains. Safe on all natural stone, tile, concrete and grout to help remove stains from oil, coffee, tea, red wine etc.

Use: stone, grout, concrete, porcelain tile, encaustic tiles and other surfaces.

What you need
  • Poultice Plus
  • Foil or plastic wrap and glue residue free tape
  • Plastic spatula
  • Clean water

For large or stubborn areas, use Poultice Powder mixed with water or the appropriate Sealers Plus chemical (refer to the Stain Removal Guide).

How to use
  1. Stir well before using as product may settle (mix to a creamy toothpaste consistency; add a small amount of water if required)
  2. Sweep, vacuum, or wipe the surface
  3. Apply 6mm thickness of Poultice Plus in a uniform coat over the stained area, covering an area slightly larger than the actual stain
  4. Cover with foil or plastic wrap and tape down borders with glue residue free tape
  5. Poke a few holes in the surface of the foil or plastic wrap
  6. Allow Poultice Plus to remain covered until it dries - this may take 24-48 hours or longer, depending on conditions
  7. When dry, remove Poultice Plus from the surface with a plastic spatula
  8. Rinse thoroughly with clean water
  9. Repeat as necessary
Limitations
  • The degree of success will be determined by factors including but not limited to the type of surface stained, the length of time the stain has been in place, and whether the surface stained is sealed or unsealed
Coverage

Coverage will vary depending on the size and depth of the stain, density, porosity, texture, surface absorption, weather conditions and the number of times the procedure needs to be repeated.

Precautions & safety directions
  • Always test first
  • Read the entire label, SDS and technical bulletin before using
  • Wear appropriate skin and eye protection
  • Surface must be clean and completely dry and free from any other sealers and coatings
  • Use when surface temperature is between 4°C and 32°C

Test first: due to the nature of different surfaces, do several test areas in inconspicuous areas according to the label instructions to determine surface colour stability and desired results. The end user must determine the suitability of the product for their intended use.

Handling, storage & clean up
  • Close container tightly after each use. Store in original container only
  • Store and use in temperatures between 4°C and 32°C
  • Wash hands and clothes with clean water before product dries
First aid

For advice, contact a Poisons Information Centre (Phone 131 126) or a doctor. If swallowed, do NOT induce vomiting. Immediately give at least 3-4 glasses of water. If in eyes, hold eyelids apart and flush the eye continuously with running water. Continue flushing until advised to stop by the Poisons Information Centre or a doctor, or for at least 15 minutes. If skin or hair contact occurs, remove contaminated clothing and flush skin and hair with running water. If irritation persists, seek medical attention.

How much do I need?

  • 5 stars: 3 (75%)
  • 4 stars: 0 (0%)
  • 3 stars: 1 (25%)
  • 2 stars: 0 (0%)
  • 1 star: 0 (0%)
D
DANEE ERICKSEN

My new kitchen was only four weeks old. My coffee machine leaked and left a large stain on the marble that I could not get off. I purchased Poultice Plus at Searlers Plus at Kurnell and it worked a treat. No stain left at all would highly recommend this product

A
Anonymous

Amazing

B
B

Did a fantastic job

C
Clare

Didnt work as well as I was expecting

Chat on WhatsApp