Grip-It T creates a fine micro-texture on the tile surface to help make slippery porcelain, ceramic and tessellated tiles safer underfoot, indoors and outdoors.
You control the result: test as you go, and once you're happy with the achieved result, pick it up and rinse it off. Made in Kurnell, NSW by Sealers Plus, Professional Grade.
GRIP-IT T1 LITRE
GRIP-IT T4 LITRE
Do not dilute. Pour into a tray or bucket, never straight onto the tiles.
Keep it wet and test until you're happy with the achieved result.
Wet vac it up, then rinse multiple times with clean water.
Not a sealer or a coating, so there's no surface film. A long-lasting slip-resistant treatment.
Prepare, treat with Grip-It T, then remove, rinse and check. Allow time to work in sections you can keep wet and control.
Clean the tiles with XtremeClean+, rinse well and let dry. Mask stainless steel, chrome, glass, natural stone and drains. Turn off underfloor heating and work out of direct sun. Surface temperature must not be below 4°C or above 28°C.
VERY IMPORTANT
Run the full process (steps 3–9) on a spare tile or hidden spot. Check for colour stability and any surface change when fully dry. Note how many applications gave the grip you want.
Wear gloves, eye, skin and foot protection. Pour into a plastic tray or bucket (never straight from the bottle onto the tiles) and apply with a sponge, roller or mop so a wet film sits evenly over the tiles. Don't spray. Work in sections you can keep wet and control.
Start timing as soon as the section is evenly wet. Add more product to keep it wet and active. You always want a wet film of Grip-It T on the surface.
Wipe a small spot with a damp cloth.
Finger test: with a gloved finger, rub firmly back and forth across the spot. It should feel grippy and drag, not smooth and glassy.
Shoe test: in a rubber-soled shoe, put your weight on the spot and do a skid/scuff or twisting motion on the tiles. Compare both with an untreated tile.
Apply a fresh coat over the whole section and test again after another 5 minutes. Repeat until you're happy with the achieved result.
Never let it dry: add more product to the surface to keep it wet and active. You always want a wet film of Grip-It T on the surface. This may take a few applications, depending on how hard the glaze is and how much grip you want. Not happy after 3 applications? Rinse and contact us.
Once you're happy with the achieved result, remove Grip-It T straight away so it stops working. We recommend a wet vac. No wet vac? Squeegee and bucket, or use a mop and bucket kept for this job and wring it out often.
Rinse multiple times with plenty of clean water and pick up each rinse. Don't let the floor dry between rinses. No wet vac? Rinse at least 3 times with fresh water each time.
Check the grip both dry and wet. Dispose of the waste water as your local council requires, never into stormwater drains or the garden.
EzyClean+: Daily / Weekly cleaning, pH neutral.
XtremeClean+: Half yearly or as needed heavy-duty clean.
Aqua-Seal Gold+: seal the grout joints after 24 hours to help reduce staining (optional).
Questions about your tiles? Call our team on +61 2 9521-4000.
